Monday, November 3, 2014

Arduino and TFT LCD Display Module



Arduino TFT LCD Display Module Test

Hardware
1.Arduino UNO Board or Compatible
2.TFT LCD 2.2 inch  from Elecfreaks ( Model  TFT01-2.2SP )
http://www.elecfreaks.com/store/22%E2%80%99-tft-lcd-tft0122sp-p-672.html


Description:

TFT LCD module has always been one of the hot products in DIY industry and LCD is basically the necessary products during all projects, at the same time, serial port modules are also the popular ones, because it takes few IO and the usage is simple. This section of the 2.2S-inch TFT LCD serial SPI integrated features of compact, SPI interface, fully compatible with popular LCD5110 interface cable sequence, and will replace the increasingly reducing LCD5110.

Feature:

TFT01_2.2 SP is a 2.2 "SPI TFT LCD Screen Module, 10pins interface, compatible LCD5110 interface. Not just a LCD break but include SD card (2GB),
The LCD in the TFT01 is ILI9341. It's a 240 * 320 (resolution), 2.2S inch TFT LCD screen.The LCD has a wide viewing angle, the contrast is also very suitable.

The display interface is serial, it just needs 5 wires (CS, RS, SCL, SDA, RST) for controlling.
Replace LCD5110, Support direct plug in ElecFreaks Joystick shield, EFCom, Key Pad Shield etc
SDcard use hardware SPI interface (CS / MOSI / MISO / SCK), Not solder pins.
Parameter:

SDO: Serial clock output
LED: 3.3V IO and Power Supply pin
SCL: Serial clock input
SDA / SDI: Serial data input
DC: Data / Command selection
RST: Reset, Low level active
CS: Chip Selection, Low level active
GND: Ground
VDD33: 3.3V Power Supply pin
UTFT Support


Wiring Diagram





TFT Pin SDO<MISO>     Not Used

TFT Pin LED                   To  VCC 3.3V

TFT Pin SDI<MOSI>      To Arduino PIN D9

TFT Pin SCK                   To Arduino PIN D8

TFT Pin D/C                    To Arduino PIN D10

TFT Pin RESET              To Arduino PIN D11

TFT Pin CS                      To Arduino PIN D12

TFT Pin GND                  To Arduino PIN GND

TFT Pin VCC                  To Arduino PIN 3V3


Software

Driver UTFT Library  by Henning Karlsen
http://henningkarlsen.com/electronics/library.php?id=52

his library is the continuation of my ITDB02_Graph, ITDB02_Graph16 and RGB_GLCD libraries for Arduino and chipKit. As the number of supported display modules and controllers started to increase I felt it was time to make a single, universal library as it will be much easier to maintain in the future.


Download Source code



My Website
http://softpowergroup.net/
email : info@softpowergroup.net   Tel .081-6452400
Google+  https://plus.google.com/+SoftpowergroupNetThailand/